top of page
Writer's pictureDIYTechnician

Troy-Built Lawn Edger Guide-Everything you Need to Know

Updated: Jun 15, 2020



For years the old lawn edgers "weed wackers" would run really good when you first purchased them and then once you let them sit for various periods of time between lawn mowing sessions, it would be hell getting them started. I've seen more weed wackers tossed across lawns in my time than homelite chainsaws. The older ones had 2 cycle motors and if you didn't have exactly the correct oil/gas mixture the weed wacker would either not start, smoke the whole place up, or the motor would bog down. I have experienced all of this first hand being starting at a young age watching my father fight these evil little machines and then also myself as I grew up mowing lawns for extra money and then of course my own. There were numerous occasions where all I had left to do was some touch up around the edges after pushing a heavy mower across meters and meters of lawn and I'd spend more time and expend more sweat trying to get the damn thing started again. Even before I'd go out on jobs, I'd make sure the damn thing started before I left my house. It would still find a way to let me down once it was needed.


Like a Sailor


The frustration caused by the old weed wackers could make a preacher swear. Ok maybe not out loud but inside. I've called these things every name in the book and have probably set the distance record for yards thrown.


Not only were the old motors an issue on the older weed wackers but the line feed mechanism on the working end of the contraption often wreaked havoc on the operator's emotions. I would venture to say that no matter what kind of weed wacker you owned back in the day, you probably had both the line feeder mechanism and/or the motor taken apart on it (except maybe a Stihl) before the first year of ownership was up. The older models made it pretty tough to change out the line or even replace it if it got stuck up inside the feeder mechanism causing much frustration and chewing up your clock. There was no youtube or internet readily available at your fingertips, you either had to figure it out or toss it.


Sore Starting Muscles


I can't count how many times that I would wake up the next day with a very sore and stiff upper back and then at first wonder what I did to it the day before. Then it dawns on me. Oh that's right, I tried starting that damn weed wacker by pulling on the pull starter 2000 times over the course of the day yesterday. Then it lingers for the next couple days just for good measure.

For changing out the line as you can see, the line feeds in or out with the clockwise or counter clockwise rotation of the center black adjuster. At some point of course, the line will run out and you will need to refill your line. So when you buy one of these make sure you pick up another pack of weed wacker line. To access the line reservoir, you'll need to grab your flathead screwdriver and depress the two tabs that are 180 degrees from each other on the side. This will allow you to pop the top cover off. Once the top cover is off, cut yourself about 6 feet of line and run it through the hole of the back inner spindle. Then route the line through the top cover islets and snap back into place. At first this seems a little counter intuitive but follow along and this will work. After the cover is snapped back into place, push the black adjustable spindle in and spin it counter clockwise. This will wind the line back onto the inner spindle. Simple huh?





Troy-Built products are available from Lowe's and other stores. My experience has mostly been from purchasing them from Lowe's and almost all of them are relatively easy to put together right out of the box. Most of the videos shown on this post are either "for dummies" style beginner videos or maybe videos I thought at the time were worthy of posting because maybe they could clear up any sort of confusion on assembly or usage. The lawnmower shown below was a cheaper model but it came to together very easily right out of the box and fired right up one I got the gas and oil put in it.



You can purchase one of these fine machines on amazon: https://amzn.to/2IFzMz3. Buy through this link and I get a little kickback from amazon.

7 views0 comments

Recent Posts

See All

Comentários


bottom of page